softening temperature
软化点
常用释义
英式发音
美式发音
基本释义
- [高分子][物] 软化温度，软化点
例句
-
1·The effect of high silicon low iron material on softening temperature, balling index, quality and output of sintering ore was investigated.分析了高硅低铁物料对铅锌矿软化温度、成球性指数、烧结矿质量与产量的影响。
-
2·Cryogenic grinding has been the development trend for ultrafine grinding of plastics, especially for plastics with low softening temperature.低温粉碎是塑料，特别是低软化温度塑料超细粉碎的发展趋势。
-
3·This paper systematically studies the effect of low softening temperature transparent glass frits composition on phosphorescence properties of photoluminescence glaze;本文系统地研究了低温软化透明釉料组成对光致发光釉发光性能的影响；
-
4·Through the use of a radial-based function neural network(RBFNN) an intelligent forecasting model for the blended-coal softening temperature was set up under MATLAB environment.采用径向基神经网络（RBFNN）在MATLAB环境下建立了混煤软化温度的智能预测模型。
-
5·The result showed that the tensile strength property and Vicat softening temperature was increased and notched impact property of PVC/ABS composite was decreased with the glass fiber added.研究结果表明：随着玻璃纤维添加份数的增加，PVC/ABS合金的拉伸性能和维卡软化温度有不同程度的提高，缺口冲击强度有所下降。
-
6·Fumaric acid has a lower softening temperature and saponification value but a higher acid value, which was beneficial to improving the quality of modified rosin size and dispersed rosin size.在加成量相同的情况下：富马松香与马来松香相比具有较低的软化点和皂化值，却有较高的酸值，有利于改善强化松香胶和分散松香胶的质量。
-
7·The best peak firing temperature was existed, which was between the softening temperature and the peak crystallization temperature, and near the incipient crystallization temperature of the glass.电阻浆料存在最佳峰值烧成温度。理论分析表明，最佳峰值烧成温度应在软化点与峰值析晶温度之间，靠近起始析晶温度。
-
8·Samples of blended coal ash were taken from the boiler of a power plant 700mw unit. Their softening temperature was measured by a pyramid method on an intelligent ash-melting point measuring device.从某电厂700 MW机组锅炉取混煤灰样，在智能灰熔点测定仪上采用角锥法对其进行软化温度测定。
-
9·The softening point of high temperature, plastic or higher to be appropriate.胶的软化点高， 胶温也要相应高些。
-
10·The wear of friction wafers in main clutch features uneven radical distribution. In the operation of friction wafers, high local temperature and material softening are important reasons causing wear.分析了主离合器摩擦片的磨损具有沿径向非均分布的特点，指出摩擦片在使用过程中，局部高温和材料软化是产生磨损的重要原因。