electroslag welding
[机] 电渣焊
常用释义
英式发音
美式发音
基本释义
- [机] 电渣焊
例句
-
1·The procedure using anneal instead of normalizing will improve the productive efficiency of electroslag welding joint.用退火代替正火后的电渣焊工艺可大大提高生产效率。
-
2·The re-bar end used for electroslag welding should be straight, flat and clean free of U-shaped, bruising, concave and convex, bending or distorted deformations.电渣压力焊焊接使用的钢筋端头应平直、干净，不得有马蹄形、压扁、凸凹不平、弯曲扭曲等严重变形。
-
3·Within 200mm area of re-bar end surface, it should be free of rust, oil dirt, concrete slurry etc. The contaminated re-bar should be cleaned for electroslag welding.钢筋端部200 mm范围不应有锈蚀、油污、混凝土浆等污染，受污染的钢筋应清理干净后才能进行电渣压力焊焊接。
-
4·According to the specification of equipment, the hardware and PLC application software have been designed. This control system has been used in double wires electroslag welding.根据设备的技术要求设计了系统硬件和PLC应用软件，该系统已用于自制双丝电渣焊设备。
-
5·Nickel rod needs to be lengthen by argon arc welding before the electroslag refinements, large welding parameters are needed to assure the sufficient penetration.金属镍在电渣精炼前需用氩弧焊焊接接长，为保证焊接接头具有足够熔深，需要大参数进行焊接。