compound die
复式压模
常用释义
英式发音
美式发音
基本释义
- 复式压模
例句
-
1·The first set is blanking and punching compound die.第一组是消隐和冲压复合模。
-
2·The structure and machining process of plane diffluent compound die are introduced.介绍了平面分流组合模的结构和加工工艺。
-
3·The design describes the structure of compound die stamping flip-chip design and working process.本次设计阐述了冲压倒装复合模的结构设计以及工作过程。
-
4·In addition, both the working process of compound die and questions required attention are stated.同时也阐述了复合模工作过程及注意事项。
-
5·Analyzed press technology characteristics of vent-windows of the car side board, designed a lancing-drawing compound die.分析了车厢侧板零件通风窗冲压加工的工艺特点，设计了一副针对该零件加工的切口拉伸复合模。
-
6·Adopting once punching process and using fewer cost and worse plasticity leftover material finish twice drawing of compound die.分析了小圆角圆筒件的成形工艺性，利用成本较低、塑性较差的角料，采用一次冲压工序完成二次拉伸的复合模。
-
7·Besides using nitrogen spring is discussed. I give another resolving method in improving the plane tolerance of compound die part.并且对氮气弹簧的应用进行了论述，对满足多工位级进模中零件的平面度要求提出了另一种解决方法。
-
8·Through the analysis of forming technology of regulator of left chair, the method of using two sets of compound die is put forward.通过对左座椅调整器的成形性工艺分析，提出了采用两套复合模结构的方法，并介绍了模具的具体结构及模具工作过程。
-
9·The application of the Shared plate technology effectively lowered the cost of the compound die and shortened the manufacturing cycle.共用模板技术的应用，有效地降低了复合模成本并缩短了制造周期。
-
10·Improved properly such mechanisms as the location, stripping and scraps treatment, the common compound die was satisfied the need of the automatic stamping.对普通复合模的定位、卸料以及废料处理等装置加以适当改进，满足了自动冲压的需要。