buckling strength
抗弯强度
常用释义
英式发音
美式发音
基本释义
- 抗弯强度
例句
-
1·Introducing the method of effective ratio of width to thickness by considering post buckling strength of channel sections in press.介绍一种考虑薄壁槽钢受压局部屈曲后强度的有效宽厚比法。
-
2·The inner cylinder may therefore be formed thin and small in diameter and particularly the stretched inner cylinder is high in buckling strength.于是，能形成薄壁小直径的内筒，特别是可以延伸，从而提高了轴向的压曲强度。
-
3·Considering the membrane effect of plates, the design of profiled steel sheets allows local buckling of plates, and can utilize post - buckling strength.由于板件的薄膜效应，压型钢板的设计不仅答应板件出现局部屈曲，而且还可以利用屈曲后强度。
-
4·When a beam flange is coped at the connection, the lateral buckling strength of the coped beam could be significantly less than that predicted by current formulas.在切去梁翼后(简称切口)梁的侧向屈曲强度会比通常采用的设计理论所计算的强度大大降低。
-
5·Allowed the local buckling of elements and made use of the post-buckling strength, the effective width method is often used to calculate the load-carrying capacity.为了用料经济，允许板件产生局部失稳，其承载能力以利用板的屈曲后强度为特点的“有效宽度”方法来计算。
-
6·It is found that the buckling strength of column-supported silos is mainly dependent on the height of the engaged column, which also affects the buckling deformation mode.研究表明，支柱伸入高度是影响仓壁柱承筒仓屈曲强度的主要因素，屈曲模态也与之密切相关。
-
7·The results prove that when the edge length keeps constant, the buckling strength decreases quickly with the increasing height, while the resonant frequency rises after an initial decline.结果表明，当蜂窝边长一定时，随着蜂窝高度的增加，屈曲强度迅速下降，共振频率先下降后升高；
-
8·For the code revising, some important conclusions have been drawn through the theoretical analysis and experimental research of the post-buckling strength of web plates of I-section girder.通过对焊接工字梁腹板屈曲后强度的理论分析及试验研究，得出了一些对规范修订有重要参考价值的结论。
-
9·The energy method is used to calculate the buckling strength of the stitched composite laminates, and the minimal potential energy is used to calculate that of the unstitched composite laminates.采用最小势能原理计算了缝纫及未缝纫复合材料层合板的屈曲强度。
-
10·The paper describes basic methods and analytical approach of buckling strength assessment of oil tank structure in detail, basing on technical specifications of buckling strength in "Common Rules".本文根据《共同规范》关于屈曲强度的技术要求，详细地阐述了油船结构屈曲强度评估的基本方法和分析步骤。